Depending on pressure, the speed can
be controlled continuously on the On/Off
switch (6) up to the speed set on knob (5).
In continuous operation with the On/Off
switch locked, the machine runs at the
speed previously selected.
Setting type of operation (Fig. 10)
ATTENTION! Set any type of
operation only when the motor
has come to a complete stop!
To set the type of operation
required, press the lock
button on the selector
switch (9) and set the selector switch by
turning the arrow symbol
clockwise
or counterclockwise to the type of
operation required. Release the lock
button to fix the selector switch in the
position selected.
Meaning of the symbols
1. – Drilling without hammer action
in wood and metal.
To do this,
insert a conventional chuck (11)
with adapter (included in delivery)
into the chuck (1).
2. – Tighten and loosen screws in
conjunction with a conventional
chuck (11) and suitable bits
and bit holders
(not supplied).
Hammer drilling in concrete
and masonry without additional
chuck.
To do this, suitable
hammer drills (14) are inserted
into the chuck (1).
Chiselling in tiles and masonry.
To this end, suitable chisels (13)
are inserted into the chuck (1).
The tool’s turning function is
switched off in this type of
operation.
Adjusting working angle.
In
this position, a chisel clamped in
the chuck can be manually
turned to set a favourable
working angle of the chisel to
the tool. As soon as the selector
switch is turned to the chisel
type of operation (
), the
working angle set is locked and
retained during operation.
Starting and stopping
The voltage of the power supply must
comply with the voltage stated on the
machine plate.
Quick-action switch (Fig. 9)
• Switching on: Press ON/OFF switch (6)
• Switching off: Release ON/OFF
switch (6)
Continuous mode (Fig. 9)
• Switching on: Press ON/OFF switch (6)
and then press locking button (7).
• Switching off: Press ON/OFF switch (6)
and release.
Switching clockwise or counter clock -
wise rotation (Fig. 11)
• For hammer-drilling, drilling, inserting
screws: Set selector switch (4) to
position "clockwise rotation".
• For loosening screws: Set selector
switch (4) to position "Left rotation".
ATTENTION! Only switch over
when the motor comes to a
complete stop!
39
5452770-Bohrhammer-man 10.04.14 13:25 Seite 39
