Meister 5410400, Original Operating Instructions, Page: 52 / 144

52
• Keep your hands away from the
sawing area. Never reach under the
work piece. Contact with the saw
blade may cause injury.
• Use suitable detectors to locate hidden
supply lines or consult the local supply
company. Contact with electrical power
lines may lead to fire and electrical
shocks. Damaging a gas pipe may
cause an explosion. Damaging a water
pipe will cause property damage and
may cause an electric shock.
• Keep your work place clean. Mixed
materials are particularly dangerous.
Light metal dust may burn or explode.
• Do not use the electrical tool with a
cable that is damaged. Do not touch
the damaged cable and pull the plug
out of the socket if the cable is
damaged when you are working with
the tool. Damaged cables increase
the risk of an electrical shock.
• Always wear protective gloves when
replacing the tools. Tools will become
warm when used for extended periods.
• Be particularly careful when using the
scraper. The tool is very sharp and
there is a risk of injury.
7 – Installation and setting
ATTENTION! Always unplug
before changing bits!
ATTENTION! Wear safety gloves
when changing tools! Risk of
injury from sharp-edged tools!
Inserting tools
ATTENTION! Switch off the
appliance, pull out the mains plug!
Insert the scraper tool (7) and the saw
tool (8) (Figure 2) in such a way into the
tool holder (2) that the cams (a) of the
holder fit into two of the gaps (b) of the
tool and ensure that it fits tightly. This
also allows you to set a comfortable
working position.
Fix the tool in place the washer, holding
screw and the adjustment wrench.
The triangular sander adapter (6) is
mounted without the washer. Make sure
you store the washer safely. Fit a
triangular sandpaper sheet with the
appropriate granulation to the hook and
eye coating, and press on.
CAUTION! Ensure that the tool is
mounted in the correct position
(Figures 3, 4, and 5). An incorrectly
mounted tool may lead to injury and
material damage.
8 – Operation
Insert plug into a 230 V~ socket.
ATTENTION! Always start the tool
before bringing it into contact
with material!
Switching on (Fig. 1)
Push the On/Off switch to "I" (ON) and
lock.
Switching off (Fig. 1)
Press the rear part of the On/Off switch
and allow the switch to slide to position
"0" (OFF).
ATTENTION! Do not lay the
machine aside until it has come
to rest!
MB-5410400-Bediene-0909.qxd 04.09.2009 14:55 Uhr Seite 52