6
Operating modes
You may operate this appliance with discharge air
mode and circulated air mode.
Discharge air mode
Intake air is cleaned with oil filters and discharged
through a pipe system.
Note:
Waste air shall not be discharged neither to
an active smoke or waste air flue nor to a flue used
for the ventilation of rooms where heating appliances
are installed.
■ If you want to discharge the waste air to a non-
active smoke or waste air flue, you shall take
permission from an authorized chimney sweep.
■ If the waste air is discharged through an outside
wall, a telescopic wall case shall be used.
Circulated air mode
Intake air is cleaned with oil filters and active carbon
filter and returned back to the kitchen.
Note:
You shall install an active carbon filter to trap
particles that cause odor in the circulated air mode.
For various possibilities to operate the appliance in
circulated air mode, please refer to the manual or
consult your authorized dealer. You may buy the
accessories required for this procedure from relevant
sales points, authorized dealers or from the online
sales center. Refer to the end of operating manual
for part numbers of the accessories.
Cleaning and protective maintenance
■ Surface may be damaged due to abrasive or
hard cleaning materials. Never use abrasive or hard
cleaning materials. Cleaning of the appliance surface
Procure the proper cleaning and protective materials
for your appliance from the authorized service.
Note: Surface of the appliance and control units are
delicate against scratches.
■ Clean the surfaces with a soft, damp cloth, dish
soap or a less active glass cleaning material. Soften
the dirt that is dried and stuck on the surface with a
damp cloth. Do not rub!
■ It is not suitable to use dry clothes, scratchy
sponges, materials that require rubbing, cleaning
materials with sand, sodium carbonate, acids or
chlorine and other active agents.
■ Clean the stainless steel surfaces on the machining
direction only.
■ Do not use stainless steel cleaners and damp
clothes for control elements.
Cleaning metal oil filters
Metallic oil filters used in the appliance traps the oil
particles inside the humidity and vapour occurred
in the kitchen. Clean the metal oil filters every
three months approximately with a normal level of
operation (1 to 2 hours per day).
■ Do not use over-active cleaning materials with acid
or javel solution.
■ Clean the holding mechanisms of metal oil filters
with a damp cloth while cleaning the metal oil filters.
■ You may wash the metal oil filters with a
dishwasher or manually.
In the dishwasher:
Note: A light discoloration or change of color may
occur when the filters are washed in a dishwasher.
This does not affect the function of metal oil filter.
■ Do not wash heavily dirty metallic oil filters with
other dishes.
■ Place the metallic oil filters on a dishwasher loosely
or freely. Do not allow metal oil filters to be jammed.
Manual cleaning:
Note: You may use a special fat solvent for heavily
soiled filters. You may buy this solvent from the
online sales center.
■ Soften the metal oil filters in hot water with dish
soap.
■ Use a brush for cleaning and rinse the filters
thoroughly afterwards.
■ Metal yağ filtrelerdeki sıvıların iyice akmasını
bekleyiniz.
Summary of Contents for MEP 191 XN
Page 2: ...2 DESENHOS TÉCNICOS ...
Page 13: ...13 TECHNICAL DRAWINGS ...