The Meinberg SyncBox N2X is synchronized by a PTP Grandmaster or by a NTP Server and can be used as a time
source for equipment that requires IRIG AM, Freq.Synth/sine, PPO (PPS, PPM, PPH, IRIG DCLS, Cyclic Pulses, Single
Shot, Timer, DCF77 Mark, Time Sync, Freq. Synth./TTL, Time Slots) or serial time string for synchronization.Optionally,
the following output configurations are available:
* 3 x PPO via BNC Out 1 - Out 3
* 2 x PPO via BNC Out 1 / Out 2 and TC AM Out 3
* PPO Out 1, Freq. Synth/sine Out 2, TC AM Out 3
* Instead of three BNC connectors, the SyncBox N2X can also be equipped with three photomos outputs: 3 x PPOs
with 2-pin sockets (DFK2),
* or with 3 x ST - fiber optical female connectors
The configuration and monitoring of the system can be done with our Meinberg Device Manager Software.
The current setup file can be downloaded here.
In order to support network management systems the SyncBox offers an extensive SNMP interface, which can be
accessed by SNMP V1. It allows the monitoring of all relevant system parameters (including operating system
parameters, network interface statistics, detailed NTP status information as well as the complete system configuration)
and can be used to alter the SyncBox configuration via SNMP set commands, too.
The used PTP stack implementation is fully compatible to all IEEE 1588 PTPv2 - systems and supports PTP
management messages.
The SyncBox N2X is equipped with a high precision oscillator ""TCXO". The oscillator determines the long-term stability
in holdover mode, ie when the synchronization with the time source is disturbed. Oscillator update to OCXO-HQ is
possible.
rev 2020.1015.1509
syncbox_n2x
Page 2/5