USB-Isolator U
ser’s Manual
_________________________________________________________________________________
_______________________________________________________________________________________
5
This is an optional procedure to change the data rate of the full-speed
USB-ISOLATOR to low speed.
In order to change the speed, it requires that the board be carefully removed
from the enclosure and this requires handling at an ESD-safe work station.
Warning: We do not recommend that you do this in the
field, as it invites potential damage to sensitive internal
circuitry.
1) Open enclosure by unscrewing Phillips head screw on bottom of the
case (a label sticker will have to be pulled up to access this screw).
2)
To Switch to Low Speed (1.5Mbps):
Remove jumpers J1 and J2 and
replace as shown below (right-most position).
Note:
If both jumpers are not set the same way the unit will not function
properly
Installation
Changing USB Speed
Note:
Default speed is set to
full-speed (12Mbps)
!