10
1
2
3
Instructions for Replacement of Sleeve
4
5
1
2
1
2
1
1
Tap the clamping bush (2) into the (new) sleeve (1).
Caution:
Ensure that the holes in the sleeve (1) are aligned
with the opening in the bracket(s) that are
welded onto the piston rod(s). DO NOT tap the
clamping bush onto the bracket or piston rod!
Tools required
: Hammer.
Position the KOOI-REACHFORKS® at hip height,
tilt the mast of the forklift slightly forward and
remover the key from the ignition switch of the
forklift.
Warning:
Do not carry out maintenance work on the
KOOI-REACHFORKS® whilst there is pressure
in the hydraulic system (remove key from forklift
ignition switch).
Pull the sleeve (1) off the fork.
Tap the clamping bush (2) out of the sleeve (1).
Tools required
: Hammer, punch Ø10
Slide the (new) sleeve (1) over the fork.
