USER MANUAL
Document reference MAODS301/E
SpeedSys300 ODS301 overspeed detection system
Edition 4 - May 2022
5 - 12
Process data tab
COMMISSIONING OF A SPEEDSYS300 ODS301
5.6 Process data tab
The Process data tab and its parameters are shown in
5.6.1 Process tab – Process data
Process data displays relevant information about the current state of the measured and
calculated process parameters (sensor input and analog output), including the minimum and
maximum values that are stored for speed and acceleration.
•
Test and reset on
The Test and reset on (off) button/command is used to activate (deactivate) the “Test and
reset” function, which will switch the relays based on the parameters/settings configured on
the Output tab and the Diagnostics tab.
•
Test and reset pulse
The Test and reset pulse button/command is used to activate the “Test and reset” function
for 100 ms, which will temporarily switch the relays based on the parameters/settings
configured on the Output tab and the Diagnostics tab.
Figure 5-5:
SpeedSys300 software – Process data tab
Summary of Contents for vibro-meter SpeedSys300 ODS301
Page 118: ...THIS PAGE INTENTIONALLY LEFT BLANK...
Page 126: ...THIS PAGE INTENTIONALLY LEFT BLANK...
