KE680
11
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and
turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 10 seconds push and release the valet switch.
The system will stop sounding and enter the disarm mode. You can now start and operate the vehicle
normally.
OVERRIDE WITH PASSWORD PIN CODE:
(
Alarm Feature
IV
-
2
Programming
)
Unlike valet switch easily found, and defeated, this system allows the consumer to program a password
pin code, offering a higher level of security.
1.
Enter the vehicle and turn the ignition switch to the 'ON’ position. (Alarm will sound.)
2. Within 5 seconds, enter your chosen first 10ths digit by pressing and releasing the valet switch.
3.
Within 15 seconds of the last entered 10ths digit, turn the Ignition switch “OFF” then “ON”.
4. Within 15 seconds, enter your chosen second 10ths digit by press and release the valet switch.
5.
Turn the ignition switch “OFF” position.
[4] Chirps form siren/horn, [3] flash from parking light and LED will turn off to indicate the system was
disarmed.
Note 1: You must override the alarm within 60 seconds. If not, the system will automatically re-arm.
EXAMPLE: To Override The System With The Password Code 83, you would;
1.
Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 5 seconds, press and release the valet switch 8 times
3. Within 15 seconds of the last entered 10ths digit, turn the Ign
ition Switch “Off” then “ON”.
4. Within 15 seconds, press and release the valet switch 3 times
5. Turn the Ignition Switch to “Off” position.
[4] Chirps form siren/horn, [3] flash from parking light and LED will go off indicating system was disarmed.
I. VALET MODE:
(System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass some functions, eliminating the need to hand your
transmitter to parking attendants or garage mechanics. When the system is in valet mode, some
functions are bypassed, however the remote panic feature and remote door locks will remain operational.
To use the valet mode, the system must first be disarmed either by using your remote transmitter, or by
operating the Manual override sequence.
Enter Valet Mode:
1. From t
he disarmed condition, turn the ignition to the “ON” position.
2. Push and hold the valet switch for 2 seconds until the LED turns on. The LED will remain on as long as
the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'on'.
2. Push and hold valet switch for 2 seconds. LED will turn off indicating system has exited the valet mode.
A parking flash to confirm enters valet mode and two parking lights flashing to confirm exit valet mode.
Remote Valet Mode:
1. Press and release
or F
button on transmitter three times within 3 seconds to enter or exit valet
mode.
2. One parking light flash will confirm you have entered ‘valet mode’ and two parking light flashes will
confirm you exited ‘valet mode’.
J. CAR LOCATOR
Press the
or
button to activate car locator function. The siren will chirp 6 times. The parking light
will flash 12 times, for you to easily locate your car.
K. PANIC FUNCTION:
(See Alarm Feature
V
– 4
Programming)
The transmitter can be used as a remote panic switch to manually trigger the system in case emergency.
1. Press and hold the
or
button for 3 second. The horn/siren will immediately sound.
2. During panic mode, the normal function of this transmitter button will be suspended. The
and
buttons can be used to lock and unlock the doors (if option is installed), however once the
button is
pressed, the vehicle’s starter disable device, (where installed) will be enable allowing the vehicle to start.
3. To stop the noise, press and hold the
or
button on the transmitter again for 3 seconds. Also if
any transmitter button other than
or
or
or
button is pressed and released, the panic
mode will be turned off immediately.
4. If the button is not pressed, the sound will automatically stop after 30 seconds.
L. STARTER DISABLE
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking
lights, and dome light will turn on to alert of an intrusion for
30
seconds. Then it will stop and automatic
reset and re-arm.
