12
PROBLEM
CAUSE
SOLUTION
No green light on
transmitter when charging
or helicopter will not charge
Power switch on the helicopter
and/or the transmitter is not in
the correct position for charging
Set the Transmitter power switch
to “ON” and then make sure the
helicopter power switch is set to
“OFF”. Plug the charge cord into
the helicopter and the green LED
on the transmitter will come on.
Charger Cord is not properly
plugged into the helicopter
charge port
Check Charger Cord’s connection
Helicopter is not flying high
enough
You are not using good throttle
control
Increase throttle speed to allow
the helicopter to gain altitude
or for the helicopter to fly at a
desired altitude.
Helicopter crashed into the
ground while landing
You may have used to much tail
rotor control stick input
Reduce the amount of tail rotor
control stick input. Only use very
little input to keep the helicopter
level and stable when landing.
You may have reduced the
throttle speed too quickly or too
much
Lower the throttle speed more
gradually to allow the helicopter
to land softly.
Summary of Contents for R/C HELICOPTER
Page 15: ...15 NOTES...
