10
ENGLISH
2.6 Startup and operation
2. Installation
1. Turn on the control unit at the main switch. The green LED (PWR) on the control unit
lights up - the boot process starts.
2. After booting the pre-installed satellites are displayed. Choose
within 2 seconds
the
desired satellite with the satellite selection buttons (up / down).
3. The control unit checks whether all components
are connected and the system is ready for opera-
tion. If the control unit found an error, the display
shows „FAIL“ behind the respective point and the
red LED (ERR) is lit continuously. If everything is
confirmed with OK now starts the search process.
During the search operation, the yellow LED indi-
cator (SEARCH) flashes.
4. After a successful search, the control unit displays the satellite ID and the yellow LED
(LOCK) lights up permanently.
Note:
To change the satellite, you can use the satellite selection buttons (up / down). The
control unit starts searching again.
Summary of Contents for Shipman
