![background image](http://html.mh-extra.com/html/megasat/caravanman-kompakt/caravanman-kompakt_user-manual_1765085024.webp)
2. Installation
06
ENGLISH
1. Prepare the glue for mounting.
2. Now take the glue on the underside of the antenna base in
serpentine lines, so that the glue can harden well to the in-
side.
3. Now place immediately (within 5 minutes after adhesive application), the antenna on
the marked fields. Press the feet slightly and evenly and fix the antenna so that it stays
in place, eg by an adhesive tape. After pressing, at least 2 mm glue must be between
antenna and surface. The adhesive is cured max. in 48 hours at +18° C and a relative
humidity of 50%. Should prevail low humidity during the assembly time, spray after
bonding in the vicinity of the antenna some water in the air some time.
4. Remove any spilled adhesive immediately with a putty knife or similar and clean the
soiled surfaces with the cleaner and a fleece cloth.
5. For safety, you can attach the antenna base additionally. Drill through the existing
holes in the respective antenna to the roof of your car and fix it with a screw and
locking nut. In order for the freshly bonded feet can not slip, wait with this work until
the adhesive has cured.
6. After the complete assembly and curing of the adhesive, a silicone fugue can be
drawn around the antenna bases.
2.2 Gluing instructions
5. Roughen the surface with sandpaper (120 grit) slightly and clean the surface again
with cleaner (NOTE: Do not touch areas) and allow the cleaner to dry for about 10
minutes.