Information:
The antenna does not have to
necessarily be operated with
two receivers!
ENGLISH
ENGLISH
08
09
1. The control cable and coaxial cable is routed inside the vehicle.
IMPORTANT:
The control cable must not be shortened.
2. Make sure when you choosing a location for the control unit and the set-top box
that both devices are in a dry and a protected place.
3. Do not place the control unit and the set-top box close to heat sources and ensure
sufficient ventilation.
4. Below are the basic connections for the antenna system are shown:
• Connect the power supply (red and black thick cable) for the control unit to your
car battery via a fuse (7 amps) to avoid a cable fire at short circuit. The yellow cable
is connected to the ignition plus of the vehicle (12 volts line only when the ignition
leads), and also protected with a fuse of 7 amps. The remaining black wire is con-
nected to the corresponding negative (ground).
• Connect the cables coming from the antenna to the control unit:
- 7 m Control cable with green connector into „CONTROL CONNECTOR“
- 10 m Coaxial cable with F-connector in „ANTENNA“
• Connect the control unit to the set-top box:
- 1,5 m Kcoaxial cable with F-connector from „RECEIVER“ to set-top box.
1. Turn on the control unit.
2. Press the SEARCH button and wait until the back part of the antenna is erected.
3. Remove the power supply to the control unit - the search is interrupted and you
can now assembly the dish.
4. After assembly the dish you can connect the power supply back on and start a
normal scan.
Indoor installation
Assembly the dish
Connection
Control unit
Control cable 7 m
Positive pole
Coaxial cable 10 m
Coaxial cable 1 m
Minus pol
Plus ignition
(+)
(-)
Zündungsplus
Second connection
only 85 Caravanman
Professional
Power supply
The Caravanman automatically moves to the folded state when the ignition key is tur-
ned. This function is only available when the controller is turned off and cables and
are connected. The control unit displayed „IGNITION“.
12V DC via battery (positive-perma-
nent systems) or optional DC power
supply 230V/12V (no charger). Ensure
that a current is assured of at least 5
amps.
set-top box
set-top box
TV
TV
(+) (-)
Note
The control cable (7 m) can not
be reduced, because that can cause
interference.
During the registration process may
not be connected to the battery
charger!
1
1
2
3
4
5
6
2
3
not in
Included!
3
4
5
5
5
6
6
HDMI
or
Scart
HDMI
or
Scart
Summary of Contents for Caravanman 65 Premium
Page 23: ...Status v2 0 Juni 2013 ...