30
Dealing with water condensate
When the inside water tank is full, the water full display
is lighted.
1.
Open the drain cover and extract it upwards.
2.
Put one container or drain cover under the drain
pipe, take off the plug on the drain pipe and let out
the condensing water.
3.
After letting out all the condensing water, put the
plug back onto the drainage outlet, then cover the
drain cover.
IMPORTANT:
This water is not suitable for
drinking.
INSTALLATION
Guide for customer
-
The customer should have a qualified power supply coincident with that printed on the tag of the air condi-
tioner. Its voltage should be in the range of 90-110% of its rated voltage.
-
Must use special circuit and efficient grounding outlet matching with the plug of the air conditioner.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali-
fied persons in order to avoid a hazard.
-
The appliance should be installed in accordance with national wiring regulations.
-
The plug should be easily accessible after installation.
-
If the fuse of the unit on PCB is broken, change it with the type of F3.15A/250V.
Selecting a best location
1.
Install the mobile air conditioner in a flat and spacious location
where the outlets will not be obstructed.
2.
A minimum clearance of 50cm from the walls or other obstacles
should be kept.
3.
The gradient can’t be more than 10 degrees with the horizontal
plane while putting and using the utensil.
Note:
1.
The air conditioner shall not be used in the laundry.
2.
The plug shall be accessible after the unit is posi-
tioned.
Installation method of replacing the window outlet
Window outlet 1
1.
Hold the upper part of the window outlet 1, then
pull it out upwards.
2.
Hold the upper part of the window outlet 2 to
make the card clasper meet to the card slot, then
press it down.
Note: The window outlet 2 is only suitable to use
for heating mode.
Window outlet 2
Drain outlet
Card slot
More than 50cm
More than 50cm
Card clasper