Using the braai
Each main burner is rated at 12,000 Btu/hr. The main
braai burners encompass the entire cooking area and
are side ported to minimize blockage from falling
grease and debris. The igniter knobs are located on
the lower center portion of the valve panel. Each rotary
igniter is labeled on the control panel.
Grilling requires high heat for searing and proper
browning. Most foods are cooked at the “HIGH” heat
setting for the entire cooking time. However, when
grilling large pieces of meat or poultry, it may be
necessary to turn the heat to the lower setting after the
initial browning. This cooks the food through without
burning the outside. Foods cooked for a long time or
foods basted with a sugary marinade may need the
lower heat setting near the end of the cooking time.
NOTE: This braai unit is designed to cook efficiently
without the use of lava rocks or briquettes of any kind.
Heat is radiated by the stainless steel flame tamers
positioned above each burner.
NOTE: The hot braai sears the food, sealing in the
juices. The more thoroughly the braai is preheated, the
faster the meat browns and the darker the braai marks.
DO NOT LEAVE THE BRAAI UNATTENDED WHILE
COOKING.
WARNING: IMPORTANT!
Before igniting:
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use. Do not use the braai
if the odour of gas is present. Do not use any other
hose connection other than the regulator hose
assembly that came with the unit.
Never substitute regulators and hose assembly for
those supplied with the braai. If a replacement is
necessary, contact the manufacturer for proper
replacement. The replacement must be specified in
the owners manual.
WARNING: Always keep your face and body as
far away from the burner as possible when
lighting.
To ignite the main and side burners
Make sure all knobs are “OFF” then turn on the gas
supply from the LP gas cylinder. Always keep your
face and body as far from the braai as possible
when lighting.
Your braai has an exclusive patented built-in ignition.
The igniter is battery operated. To ignite each
burner simply push and turn the control knobs to the
HI setting, you will hear gas flow through. Press and
hold the Ignition button until burner ignites.
30
Operating Instructions
Braai ignition instructions
