Rigging the fixture
Caution!
1. The installations must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures if you have doubts concerning the safety do not install.
3. Unit is to be 24 inches away from flammable materials. (Decoration material)
4. Use high quality installation equipment to hang unit.
When rigging a unit it is very important that you follow common safety procedures. Rigging requires extensive experience including
but not limited to calculating working loads, material being used and periodic safety inspections. If you lack these qualifications, do
not attempt the installation yourself, instead use a professional structural rigger.
When rigging the unit always be secured with a secondary safety attachment. The installation location of the projector has to be
built in the way that it can hold 10 times the weight for 1 hour with out any harm to the unit. Installation should be checked at least
one time a year by a skilled person.
Cleaning and Maintenance
I
nstallation Maintenance:
The operator has to make sure that the unit is operating safely and has the installations and electronics checked by
an expert every 2 years.
The following points have to be considered during the inspection:
1) All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
2) There must not be any deformations on the housing, fixation and installation spots (ceiling, suspension, trussing).
3) The electronic power supply cables must not show any damage, material fatigue (e.g. porous cables) or sediments.
Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any safety problems have to be
removed.
Note:
There is no serviceable parts inside the device except for the LED’s. Maintenance and service operations are to be carried out by
authorized dealers.
Replacing the fuse:
When possible, only replace the fuse with the same type and rating.
Replacing the power cable:
If the power cable of this device becomes damaged, it has to be replaced by authorized dealers or a trained
professional only.
Should you have further questions , please contact your dealer.
Parts List
6
3010-FAN
7065-PCB-MAI
7065-POW
7065-LED
7065-LED-MOD
3010-MUL
3010-KNO
3010-RC
REPLACEMENT FAN
MAIN PCB CARD
WHITE LED REPLACEMENT
WHITE LED MODULE
MULTIPLE UNIT HANGER
KNOB SET
6 UNIT ROAD CASE
POWER SUPPLY
