Cleaning and Maintenance
Installation Maintenance:
The operator has to make sure that the unit is operating safely and has the installations and
electronics checked by an expert every 2 years.
The following points have to be considered during the inspection:
1) All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
2) There must not be any deformations on the housing, fixation and installation spots (ceiling, suspension, trussing).
3) Mechanically moved parts like axles and other must not show any traces of wearing and must not rotate with unbal-
ances.
4) The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments.
Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any
safety problems have to be removed.
Disconnect from mains before starting maintenance operation!
Caution Danger to life!
We recommend a frequent cleaning of the device. Please use a moist, lint free cloth. Never use alcohol or solvents!
1) The objective lens will require periodic cleaning on usage and environment. Environment with foggers will require
more periodic cleaning as fog fluid tends to build up residues, reducing the light output.
2) The cooling-fans should be cleaned monthly. DO NOT blow high pressure air into fans as incorrect rotation can
damage the fans operation.
3) The gobos, dichroic color filters and internal lenses may be cleaned with soft brush using soapy water.
4) The interior of the fixture should be cleaned using a vacuum.
5) We recommend proper lubrication of the motor wheel. The quantity of the oil must not be excessive in order to avoid
oil run outs when motor wheel rotate
Note:
There is no serviceable parts inside the device except for the fuse. Maintenance and service operations are to be
carried out by authorized dealers.
Replacing the fuse:
Only replace the fuse with the same type and rating.
Replacing the power cable:
If the power cable of this device becomes damaged, it has to be replaced by authorized
dealers only
Should you have further questions , please contact your dealer.
11
Parts List
5200-LED-MOD-I
LED Module Inner (segment)
5200-LED-MOD-C
LED Module Center
5200-LED-MOD-R
LED Module Reflective Ring (half)
5200-LED-MOD-RC
LED Module Reflective Center (1/3)
5200-LED-MOD-O
LED Module Outer Ring (half)
5200-POW
Power Supply
5200-PCB-DRI-A
PCB Driver A
52000-PCB-DRI-B
PCB Driver B
5200-PCB-POW
PCB for Power Distribution
5200-BEZ-RIN
Outer Ring Milky Diffusion Plastic
5200-BEZ-CEN
Center Globe Filter Plastic
5200-PCB-MAI-DIS
Display and Main PCB
5200-FAN-X.W
X.W-6010M24B Fan
5200-HOU-NET
Housing Net
5200-HOU-KNO
Housing base for Knob
5200-KNO
Knob
5200-FAN-HW5
HW5020B Fan
5200-HOU-QUI
Quick Release Clamp Mount
3012-CON-3PI
3 pin XLR In/Out
3012-CON-5PI
5 pin XLR In/Out
3010-CON-POW-F
Lequin Power Output White
3010-CON-POW-M
Lequin Power Input Blue
Summary of Contents for Circa
Page 2: ......
