AUGUST/30/2004
Q. TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold
button on the transmitter for two seconds to remote control the trunk
release or other electric devices.
R. CHANNEL 4 TIMER CONTROL OUTPUT
(See Alarm Feature
9
Programming.)
Press the transmitter
and
buttons at the same time to active Channel 4 function.
Channel 4 is user-programmable timer output. You may program the built-in timer to send
a ground signal for any time duration from 1 second to 120 seconds. For instance, this
timer output may be used to turn on the headlight, power window or sunroof. (Factory
defaults setting at momentary output.)
S. CHANNEL 5 TIMER CONTROL OUTPUT
(See Alarm Feature
10
Programming.)
Press the transmitter
and
buttons at the same time to active Channel 5 function.
Channel 5 is user-programmable timer output. You may program the built-in timer to send
a ground signal for any time duration from 1 second to 120 seconds. For instance, this
timer output may be used to turn on the headlight, power window or sunroof. (Factory
defaults setting at momentary output.)
T. CHANNEL 6 TIMER CONTROL OUTPUT
(See Alarm Feature
11
Programming.)
Press the transmitter
and
buttons at the same time to active Channel 6 function.
Channel 6 is user-programmable timer output. You may program the built-in timer to send
a ground signal for any time duration from 1 second to 120 seconds. For instance, this
timer output may be used to turn on the headlight, power window or sunroof. (Factory
defaults setting at momentary output.)
U. POWER ON MEMONRY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if the power
is lost and then reconnected.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button twice on the transmitter
2. The parking light will activate to indicate the remote start received the signal. (A
melody sounding from your Remote LCD transceiver and “
” icon will flashes on the
LCD screen to confirm the remote start was activated.)
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking light will turn on again
and climate controls will activate and adjust the vehicles interior temperature to your
preset setting. (While the vehicle is running, the “ ” icon and the “minutes” digit on
the LCD screen will flash and it will indicate count down timer based on the 5, 10, 20,
or 30 minute run time set up by your installation center.)
5. The vehicle will run for 10 to 60 minute cycle and automatically shut down. (When the
unit shuts off the count down timer will turn off and the transmitter will play a melody.)
Note:
The Remote Start Unit will not start the vehicle if any one of the following
conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”
Activate
Remote Start
Engine
Running
B. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
To operate the vehicle while engine running on the remote start.
1. Insert the ignition key and turn it to “ON” (not the start) position.
MEGA3700OP
6
