Test Mode
In this test mode, this system can test the Zone 1 Warn Away Trigger / Zone 2 Instant ground trigger /
Zone 3 Door trigger and the Zone 4 optional sensor sensitivity. The installer can save time to test the
optional sensor sensitivity and sensor without using the traditional arming/disarming procedures to test the
sensors.
Enter:
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in the OFF position.
2. Push the Valet switch
8
times and hold it on the
8
th
push until
four
chirps with a long chirp is heard.
Then release the valet switch. You are now in the Alarm feature
‘IV’
programming mode.
3-a. Test the Zone 2 Instant Ground Trigger & Zone 3 Door Trigger:
Press and release the transmitter
button once. [1] LED flash, [1] siren/horn chirp to indicate you
are in Zone 2 / instant ground trigger and Zone 3 / Door trigger test mode.
Trigger sensor
Siren chirps
Zone 2 / Instant Ground trigger (H7/2 Blue/White wire)
2
Zone 3 / Door trigger (H7/3 Violet & H7/5 Green Wire)
3
3-b. Test the Zone 1 / 2 Shock Sensor
(Connected to
H2
4 Pin Plug)
:
Press and release the transmitter
button again. [2] LED flash, [2] siren/horn chirps to indicate you
are in shock sensor (connected to
H2
4 pin plug) test mode.
1. Activate the warn-away (first stage optional sensor). The system will emit a short chirp.
2. Activate the full alarm (second stage optional sensor). The system will emit a long chirp.
3. Continue to test the optional sensor until you reach the proper sensitivity.
Return To Factory Default Setting:
1. Turn the ignition ON then OFF 3 TIMES and stay in the OFF position.
2. Push the Valet switch
12
times and hold it on the
12
th
push until
six
chirps with a long chirp is heard.
Then release the valet switch. You are now in the “Return to Factory Default Setting” programming
mode.
3. Press the
and
buttons at the same time on the transmitter together for 5 seconds, there will be
a confirmation six chirp with 3 long chirp to confirm the system Alarm Feature I & II & III & IV
Programming all returns to factory default setting.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
MEGA 2550 INSTALL
11
Summary of Contents for MEGA 2550
Page 2: ...MEGA 2550 INSTALL 2...
Page 12: ...MEGA 2550 INSTALL 12...
