34
www.mega-motion.com Elite 8
Frame Separation
1. Lower the tiller and tighten the tiller adjustment knob.
2. Remove the frame lock-up pin.
See figure 26
.
3. Lift up on the seat post and pivot the rear section backwards until the frame hooks are no longer resting
on the lower frame tube.
4. Slowly separate the two sections of the Travel Scooter.
See figure 27
.
V I I . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
NOTE: Before attempting assembly, tilt the rear half of the Travel Scooter slightly back on the anti-tip
wheels as show in figure 27.
1. Use the seat post to lift the front section as you align the frame hooks of the front section with the lower
frame tube of the rear section.
See figure 27.
2. Once the frame hooks are over the lower frame tube, lower the front section completely.
3. Pivot the rear section forward; this will engage the frame lock up.
4. Reinstall the frame lock-up pin.
5. Raise the tiller and fully tighten the tiller adjustment knob.
6. Reinstall the battery pack.
7. Reconnect the battery and front-to-rear harnesses.
8. Reinstall the seat and rotate it until it is secured into place.
9. Unlock the front wheel by turning the tiller lock knob 90° counterclockwise.
See figure 24
.
WARNING! After assembly, make absolutely certain the tiller lock knob is in the unlocked
position before driving the Travel Scooter.
Figure 27. Frame Separation
Figure 26. Frame Lock-Up Pin
FRAME HOOK
LOWER FRAME TUBE
FRAME LOCK-UP PIN
