LED Moving Head Wash 3610 MJ-1006C User Manual ver2.0
www.mjledlighting.com
10
六：
Information
1.
Press “MENU” button to information confirm by press “ENTER” button. It will show
Power On Hours, Power this time ,Head Sensor, Software Version.
2.
Press “ENTER” button to save and quit. Press “MENU” button to quit no saving.
七：
Reset
1
、
Press “MENU” button to Reset,
，
confirm by press “ENTER” button, it shows reset.
Maintenance:
To prolong the life of the projector, some maintenance work has to be done to ensure the
LED optical system in good condition. If the projector does not function, check the fuses
on the power socket of the projector, they should only be replaced by fuses of the same
specification. Should these be damaged, call a qualified technician before replacement.
The projector has thermal protection device that will switch off the projector in case of
overheating. Should either of these operate, check that the fans are not blocked, and if
they are dirty, clean them before switching on the projector again. Check that the fans
are operational, if not, call a qualified technician.
☆
Any maintenance work should only be carried out by qualified technicians.
Keeping The Product Clean:
To ensure the reliability of the projector, it should be kept clean. It is recommended that
the fans should be cleaned every 15 days. LED lens should also be regularly cleaned to
maintain an optimum light output.
Cleaning frequency depends on the environment in which the fixture operates: damp,
smoke or particularly dirty surroundings can cause greater accumulation of dirt on the
unit's optics. A soft cloth and typical glass cleaning products should be used for cleaning.
It is recommended to clean the external optics at least once every 15 days.
☆
Do not use any organic solvent, e.g. alcohol, to clean housing of the apparatus.
Trouble Shooting:
Problem
Answer
The LED moving head light doesn’t switch
on.
Check the fuse the power socket
Although shines, but the LED moving head
lamp doesn’t accept the instruction of the
controller.
Check the digital start address and
also check the connection situation of
the communication control line
LED moving head lamp only can work
intermittently.
Inspect the power supply and voltage
is whether normal.
Do not receive the DMX512 signal.
Whether the signal lines do contact
well or broken.
The light beam appears gloomily.
Check that the heat dissipation
system is running normally or Inspect
the optics part is whether clean.
☆
Other maintain work should by the specialist which has the experience to carry on.
