Meech CyClean, Operating Manual

Page: 14 / 44

14
Setting the Required Air Pressure
There is a pressure relief regulator valve inside the CyClean control box. Adjusting this valve will change the air pressure that will
be fed to the cylinders mounted as part of the CyClean head.
This valve will have been set at Meech before your system was supplied.
CAUTION
If you need to adjust the pressure relief valve, make sure that it is not adjusted to provide maximum pressure. If too high a
pressure is used, it may result in damage to your system.
Adjustment of Head Opening and Closing Speed/Force
The speed/force at which the CyClean head opens and closes can be independently adjusted. This will be adjusted by Meech
before your system is supplied so that:
„
Open = medium to fast operation
„
Close = slow speed
The speed can be adjusted using the valves on each of the cylinders.
IMPORTANT
When making any adjustment it is very important that all 4 cylinders are adjusted at the same time to the same setting. If this
does not happen it can damage your system.
CAUTION
It is recommended that the closing speed/force of the head is minimal, as this is a pinch point that could cause injury.