Meec tools 721-382, Operating Instructions Manual

Page: 27 / 33

EN
27
the paving stone cleaner.
• Only use the paving stone cleaner in a vertical position with the brush positioned against the ground.
Never start the paving stone cleaner in any other position.
• You should only move the paving stone cleaner around on foot.
• Do not press the paving stone cleaner against the surface.
• Always keep hands and feet away from the brush.
• Avoid touching the brush.
• Check the power cable is not touching the brush.
• Switch the paving stone cleaner off and wait until the brush has fully stopped before laying the paving
stone cleaner down. Never attempt to stop the brush.
• Check that the paving stone cleaner’s maximum speed does not exceed the brush’s maximum
permitted speed.
• Discolouration from rust or other signs of chemical or mechanical changes to the brush could lead to
defects.
• Store the brushes in suitable holders or containers in order to protect them from the following:
– High humidity, heat, water or other liquids which could damage the brushes.
– Exposure to acid or acidic fumes which could decompose the brushes.
– Low temperatures which could cause condensation when the brushes are moved to an area
with higher temperatures.
– Distortion of the brush’s parts.
• Note that the brush will continue to rotate for a moment after the paving stone cleaner has been
switched off.
• Only use brush types recommended by the manufacturer.
• Disconnect the plug from the socket after you have finished working with the paving stone cleaner,
before any service and whenever the paving stone cleaner is not in use.
• Store the paving stone cleaner in a safe place out of reach of children.
ELECTRICAL SAFETY
• Check that the mains voltage corresponds to the rated voltage on the rating plate.
• The paving stone cleaner should be connected to a power circuit protected by an RCD of max. 30 mA.
• Only use extension cables of the following types: H05VV-F, H05RN-F and H05RR-F.