Meec tools 022358, Operating Instructions Manual

Page: 17 / 30

EN
17
PACKAGE CONTENTS
Unpack the product and check that all the
parts are included and undamaged.
A. Stand for mitre saw
B. Roller support, 2x
C. Saw bracket with quick-coupling, 2x
D. Transport handle
E. Wheel, 2x
F. Axle, 2x
G. Flat washer Ø12, 2x
H. Flat washer Ø8, 2x
I. Spring washer Ø8, 2x
J. Screw M8 x 14 with round head, 2x
K. Lock nut M8, 4x
L. Lock knob, 2x
M. Assembly parts for mitre saw (screw, flat
washer, spring washer and nut), 4x.
FIG. 1
INSTALLATION
TOOLS
• Phillips screwdriver (PH2)
• Spanner 13 mm
• Spanner 10 mm
FITTING TRANSPORT HANDLE
1. Place the stand on the floor, with the
retracted legs turned up.
2. Fit the transport handle on the frame with
two M8 x 14 screws with round head (J),
flat washers (H) and spring washers (I).
Firmly tighten.
FIG. 2
UNFOLDING LEGS
1. Press the release lever on the leg catch
and unfold the first leg until the lock pin
clicks in place.
2. Repeat for the other three legs.
3. Turn over the saw table and stand it on
the legs. Check that all the legs are firmly
in contact with the surface.
1. Leg
2. Release lever for leg catch
3. Lock pin
FIG. 3
FITTING THE WHEELS
1. Fit one wheel on the end of one axle and
fasten with a circlip on the end of the axle.
2. Check that the circlip snaps in place
correctly in the slot and holds the wheel
firmly in place. Repeat for the other
wheel.
FIG. 4
FITTING ROLLER SUPPORTS
1. Fit the roller support post (B) in the
housing.
2. Hold the roller support at the required
level and tighten the knob (L) to lock in
this position.
3. Repeat for the other roller support.
4. The roller supports can be adjusted
lengthwise and vertically if the
corresponding lock knob is released.
FIG. 5
FITTING MITRE SAW
Fit the mitre saw on the bracket with quick-
couplings with the supplied attachment parts
(screws, washers and nuts) as shown in figure.
1. Screw
2. Nut
3. Spring washer
4. Flat washer
FIG. 6