ENGLISH
38
Only use suitable blades with the correct centre hole for the tool. Blades that do not fit properly on
the tool will run eccentrically, which results in inferior control.
Do not use a damaged or unsuitable outer flange, or a damaged clamping screw. The clamping
screw and outer flange have been specially designed for the tool, for optimal performance and
safety.
Allow the blade to reach maximum speed before applying it to the workpiece.
Never try to stop the blade by pressing against the side of the blade.
Switch off the tool and wait until all moving parts have completely stopped before putting down the
tool.
Do not expose the tool to excessive strain, knocks, extreme temperatures or moisture.
Causes of kickback and ways to prevent it
Kickback can suddenly occur if the blade gets stuck, jams or is incorrectly adjusted. The tool can
kickback out of control up from the workpiece towards the user.
Kickback occurs during incorrect use of the tool and/or incorrect working methods or conditions, but
can be prevented by taking the following measures.
Hold the tool firmly with both hands and hold your arms in a position that prevents kickback. Stand
to the side of the blade, not in line with it. Kickback can cause the tool to jerk backwards, but the
user can control this by taking the appropriate measures.
If the blade jams or the sawing is interrupted for any reason, release the power switch and hold the
saw still in the material until the blade has completely stopped. Never attempt to remove the tool
from the workpiece, or to pull the tool back, while the blade is still moving
– this is when kickback
can occur. Check and rectify the reason why the blade has jammed.
When restarting the saw in the workpiece, centre the blade in the kerf and check that the teeth are
not gripping the material. If the blade jams it can slip or kick back from the workpiece when the saw
is started again.
Support large boards to minimise the risk of kickback or the blade jamming. Large boards often sag
under their own weight. Supports must be placed under the board on both sides, close to the
cutting line and close to the edge of the board.
Do not use blunt or damaged blades. Blades with blunt or damaged teeth produce more friction,
which can cause the blade to jam and increases the risk of kickback.
Lock the depth stop before starting the work. The blade can jam and the tool kick back if the setting
is changed while the tool is running.
Be extra careful when plunge sawing if you cannot see the back of the workpiece. The blade can
come into contact with concealed objects, which can cause the tool to kick back.
Switch off the tool and wait until all moving parts have completely stopped before putting down the
tool. An unprotected and freely rotating blade can cause the tool to move backwards, and cut
everything in its path. Bear in mind that it takes a while for the blade to stop after you have
released the power switch.
This is why the saw should not be used in a permanent fixture.
Do not use the tool if the power cord or plug are damaged, if the tool is not working properly, or if it
is damaged in any other way. Repairs must be carried out by qualified service personnel.
Before using for the first time
Take the tool out of the packaging and check that it is undamaged. Do not use the tool if it is damaged.
Keep the packaging material out of the reach of children
– risk of suffocation.
Applications
The tool is designed for sawing in wood and other similar materials, plasterboard, fibre concrete
and plastic. With a special blade the tool can also be used to saw aluminium.
The tool must only be used with guide rails approved by the manufacturer. The use of non-
approved guide rails or workbenches can result in serious personal injury.
Summary of Contents for 020-186
Page 46: ......
