EN
22
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output
900 W
Cutting depth
19 mm
Speed 10800 rpm
Blade capacity
100x22 mm
Cord length
2 m
Weight 3 kg
Sound pressure level, LpA: 89.0 dB(A), K= 3 dB
Sound power level, LwA:
100 dB(A), K= 3 dB
Vibration level:
5.1 m/s2, K= 1.5 m/s2
Always use ear protection!
The declared values for vibration and noise, which
have been measured according to a standardised
test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 60745-2-19:2019.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
Biscuit jointer that cuts slots for joining biscuits.
With angle guide 0-135° and depth stop with
seven fixed steps. Has dust extraction with
collector for cleaner work and a stable support
handle. Blade included.
1. Power switch
2. Support handle
3. Spindle lock
4. Angle stop
5. Scale for angle adjustment
6. Knob to adjust the cutting depth
7. Clamping screw to adjust angle
8. Clamping screw to adjust height
9. Knob to adjust height
10. Scale to adjust height
11. Base plate
12. Connection for dust bag
13. Dust bag
14. Motor unit
FIG. 1
USE
The tool is intended for cutting slots in
materials such as wood, plywood, particle and
fibre boards, plexiglass and artificial marble.
The tool is not intended for commercial use.
ADJUSTING THE BIT DEPTH
1. Move the motor unit (14) as far back as
possible.
2. Adjust the cutting depth with the
adjusting knob (6).
3. Move the motor unit forward and check
that the pin goes in the slot in the
adjusting knob.
ADJUSTING THE CUTTING ANGLE
Adjust the cutting angle by undoing the
clamping screw (7) and moving the angle stop
(4) to the required angle.
Summary of Contents for 018719
Page 3: ...1 ...