Meec tools 015177, Operating Instructions Manual, Page: 46 / 81

EN
46
ERASURE OF FAULT CODES
1. Use the up and down button to mark [Erase fault codes] in the
diagnostic menu and press OK to confirm.
FIG. 32
2. A warning message with request for confirmation is shown.
Press OK to confirm or ESC to cancel.
FIG. 33
3. Switch on the ignition, but do not start engine, and press the OK
button to continue.
4. Emission related fault codes have been erased.
FIG. 34
I/M READINESS
Use the up and down button to mark I/M Readiness in the diagnostic
menu and press OK to confirm.
– Read Codes
– Erase Codes
– I/M Readiness
– Data Stream
– Vehicle Information
FIG. 35
DATA STREAM
Use the up and down button to mark Data Stream in the diagnostic
menu and press OK.
FIG. 36