EN
24
• Only lift the vehicle at the lifting points
specified by the vehicle manufacturer.
Read the operating instructions for the
vehicle.
• Place the vehicle on a firm, level surface.
• Use a jack that is approved for the
vehicle’s weight.
• Never work or spend time under a raised
load that is not supported at the lifting
points with approved supports, such as
jack stands.
• Never work or spend time under a load
that is only resting on hydraulic lifting
equipment.
• Some vehicles may have different threads
on the wheel nuts/bolts on the right and
left sides. Check this before starting work,
so that the connections are not tightened
more firmly by mistake.
• Place the wheel nuts/bolts in position and
tighten at least 3 turns by hand before
tightening, as otherwise there is a risk of
the threads being damaged.
LOOSENING WHEEL NUTS/BOLTS
1. Place a socket of the correct size on the
product’s mount (1). Use hexagonal
sockets for impact wrenches.
2. Check that the socket covers the entire
nut/bolt head.
3. Hold the product firmly with one hand
around the front end of the product and
the other on the handle (5).
4. Press the top part of the power switch for
left drive (loosening).
NOTE:
Do not operate the impact wrench for longer
than 15 seconds in the same direction if the
wheel nut/bolt does not loosen. Follow the
instructions below if the wheel nut/bolt does
not loosen.
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 62841-2-2:2014.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the tool
is used and the material being processed.
It is therefore necessary to determine which
safety precautions are required to protect
the user, based on an estimate of exposure
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start-up time).
DESCRIPTION
1. 1/2’’ square retainer
2. Ventilation openings
3. Motor cover
4. Ventilation openings
5. Handle
6. Power switch with direction selector
FIG. 1
HOW TO USE
PREPARATIONS
• Vehicles with manual gearbox: Park the
vehicle and apply the parking brake.
• Vehicles with automatic gearbox: Park the
vehicle, move the gear selector to position
P (parking) and apply the parking brake.
All wheels that are in contact with the
ground must be wedged, so that the
vehicle cannot move.
Summary of Contents for 009516
Page 4: ...2 3 1...
