22
Appendix
■
Mounting Commercial Arms
Be careful not to place your hand when you remove the stand, as this may result in injury.
Do not press and hit the panel, as this may cause damage and result in injury.
Do not detach the tilt-stand for other purpose.
Be careful not to fall the tilt-stand and put your finger under it, as this may result in injury.
Read the instructions for the arm before attaching to the
monitor.
This attaching operation is your responsibility. We are not
to be responsible for any trouble related with this attaching.
More than 2 personnel is required if it is impossible to fix
the monitor when this attachment is carried out. This can
reduce the risk of injury.
[Applicable arm dimension and standard]
Thickness of attaching part : 2.3mm to 3.2mm. Complying with VESA standard (75mm attaching pitch)
Confirm that all screws are tightened properly, to avoid their loosing. (Proper torque : 98 to 137E•cm)
.
Please give the monitor side tightening depth of the screw as 10-11mm.
The screw used to install the tilt stand cannot be used. Please prepare the M4 x 10mm screws.
When the screws other than specification are used, it causes the injury and damage.
How to detach the tilt-stand
How to attach an arm
Select the arm that is strong enough to support this device. (The mass of the display section is approx.4.0kg)
Lay the monitor on its panel, on a soft cloth and flat surface.
Handle the monitor with care so as not to scratch it, as its panel is sensitive.
*Above figure is representative example.
75mm
100mm
Remove
screws
Remove screws
It firmly supports it.
It firmly supports it.
Push
1
Please improve it
slowly while
expanding the
lower side of the
stand cover (top)
in the back of the
monitor by both
hands.
2
Two screws are
removed by
turning the screen
of the monitor
below, laly down
slowly, and using
the plus driver.
3
Please improve
the tilt stand, and
push a certain
stopper to the
stand root in an
opposite hand. At
this time, please
support the stand
firmly so as not to
place the finger.
4
Please improve
the stand to the
right angle, and
support it firmly.
Two screws of the
remainder are
removed by an
opposite hand.
So as not to drop
the tilt stand, it
removes by both
hands.
Stand cover
(top)
Commercial arm (75mm pitch) compatible with VESA standard can be attached with this device.
Attaching part
screws
Thickness:
2.3mm to 3.2mm
1
2
1
Summary of Contents for TSD-AT1513-CN
Page 24: ...40D871064A10 ᢏ ࡀᨭ ࡿ ᮍ᮶ ...
Page 47: ......
