Do NOT use household cleaners, chemicals, solvents, bleach, scouring pads or sharp
instruments to clean your transmitter. Small amounts of rubbing alcohol can be used
to clean the surface of your transmitter. Never put your transmitter in the
dishwasher or use very hot water to clean it.
Do NOT use a hair dryer, microwave oven, or conventional oven to dry your
transmitter. Use a soft towel.
Do NOT clean your transmitter while it is in use.
Please remove the sensor if redness, bleeding, pain, tenderness, irritation, or
inflammation develops at insertion site, of if you experience unexplained fever.
The sensor may create special needs regarding your medical conditions or
medications. Discuss with your healthcare providers before using the sensor.
If failure or damage of your transmitter is found during usage, please contact
customer support or your local Medtrum distributor for replacement.
Radio Frequency (RF) Communication
Note: The TouchCare® transmitter can generate, use, and radiate radio frequency
energy, and may cause harmful interference to radio communications. There are no
guarantees that interference will not occur in a particular installation. If the
TouchCare® transmitter does cause harmful interference to radio or television
reception, you are encouraged to try to correct the interference by one of the
following measures:
• Move or relocate the TouchC
are® transmitter.
• Increase the distance between the TouchCare® transmitter and the other device
that is emitting/receiving interference.
Common consumer electronic devices that transmit in the same frequency band
used by the TouchCare® transmitter may prevent communication between the
transmitter and the receiver. This interference, however, does not cause any
incorrect data to be sent and does not cause any harm to your device.
RF communication between your transmitter and receiver works up to a distance of
10 meters (33 feet).
Charge the Transmitter
The TouchCare® transmitter is charged via a USB charging cable which is plugged
into a USB 2.0/3.0 port or a power adapter with a rated voltage of DC 5 V and a rated
current higher than DC 100 mA. The device with the USB port and the power adapter
must comply with EN 60950-1 or EN 60601-1.
The battery must be fully charged the first time using the transmitter, which may
take up to 2 hours. It is recommended to recharge the transmitter after each sensor
