D-0126021-A
11
Calibrate Coupler Response
and HIT Box Verification
Place the coupler microphone (green) between 2 and 8mm from the
reference microphone (blue). Use the large O-ring to raise the coupler mic to
the same level as the reference microphone as shown in picture below.
In the Studio software go up to the top right menu bar:
•
Click the three vertical dots.
•
Click on the check mark. The HIT Box Verification widow
will pop-up.
Click start and blue lines will show up on top of the calibration lines. Those
lines will turn green when that calibration test passes or will they will turn
red if that test fails.
See picture below.
If you do not get green calibration line responses, make sure the coupler mic
is in the proper position and re-run the calibration.
