7. Attach the interface accessory of your choice to the top section of nebulizer.
8. Plug the power cord into an appropriate electrical outlet. Make sure at this
stage, the power switch is at “OFF” status.
9. Press the power switch to “ON” status to begin your prescribed treatment.
Important:
The compressor motor has a thermal protector which will shut off the unit
before the unit is overheated. When the thermal protector shuts the unit off,
please:
a. Switch off the unit.
b. Unplug the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before another treatment.
d. Make sure the air openings are not obstructed.
10. When treatment is finished, shut off the unit and unplug it from the electrical
outlet.
5. CLEANING
It is recommended that the nebulizer and the mask (or other patient accessory
interface used) are thoroughly cleaned with hot water after each use and cleaned
with a mild detergent after the last treatment of the day. If your physician or
respiratory therapist specifies a different cleaning procedure, follow their
instructions.
Caution:
Before cleaning, make sure the power cord is disconnected from the main outlet
and the unit.
Rinsing (after each treatment)
1. Disconnect the air tube from the nebulizer. Disconnect the mask or other
patient accessory interface from the nebulizer.
2. Gently twist the top part of the nebulizer counter-clockwise to disassemble
the nebulizer.
3. Rinse the nebulizer and mask (or other patient interface) with water.
4. Let these components air dry, away from direct sunlight.
5. Reassemble the nebulizer when completely dry and put these parts in a dry,
sealed container.
5
