MDS86825DLX3/4 (GPI171)
Revised (A): 11/26/12
Wheel Assembly
Figure C
Figure B
Figure A
Recommended Height:
Your feet should comfortably touch
the ground when you are seated on the
rolling walker.
Height Range:
Under 5' (152 cm)
Hole 1 or 2
5'1"-5'6" (155-170 cm) Hole 3 or 4
5'7" (173 cm) and over
Hole 5 or 6
Note:
These are only recommended
heights, as each individual is built
differently.
Turn the rolling walker upside down so that
the seat of the rolling walker is facing the
floor. All four leg extensions should face
upward for proper placement of the wheels.
Rear Wheel Assembly
1.
Position the wheel so that it is facing the outside of the rolling walker
(see Figure A)
.
2.
Insert the wheel to the desired height depicted by numeric holes on the wheel frame
(see Figure B)
and use the chart below for the recommended height settings.
3.
Insert a triangular hand screw into the hole on the same side of the wheel so that
the triangular hand screw stays outside of the rolling walker frame
(see Figure C)
.
4.
Tighten the triangular hand screw
(Important: Hand Tighten Only!)
until secure
(see Figure C)
.
5.
Repeat steps 1-4 for other rear wheel.
7
