Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 82010
8
If the signal indicator led remains off, switch on the audio source and increase its
output level until the red indicator light comes on.
Putting the batteries into the headphone
The batteries must be fully charged before first use. An initial 24 hour
charge is required to guarantee an acceptable service life for the
rechargeable batteries. Always ensure that the headphones are
switched to the position
OFF
while the batteries are charging.
1.
Remove the small cover on the battery compartment on left side of the
receiver headphone.
2.
Install two AAA sized, rechargeable NiMH batteries (type HR03) according to
the correct polarity (marked in the battery compartment).
3.
Close the battery compartment.
4.
Switch off the receiver headphones and place it into the transmitter to charge
the batteries for 24 hours before the initial use.
Using the headphones
6
Using this appliance at full volume for extended periods of time
may cause damage to the hearing capacity of the listener.
In the first instance set the volume of the audio device to a value
at the lowest end of the scale before you put on the headphones.
Then select a comfortable volume. Excessive volume can damage
your hearing
.
Switch on
1.
Turn on the audio source (TV set or any audio devices) which the transmitter
has connected.
2.
Switch on the headphones.
3.
Place the headphones on your head and adjust the volume to obtain the
desired sound level.
4.
If you cannot find the best reception frequency, press the "Auto Scan" button
on the headphones to get the fine scanned channel.
You should then be able to move around freely from one room to another
without any interference. If interference does occur (interruptions in the
signal), press the "Auto Scan" button once to find a better reception channel.
A
For better stereo reception, stay approximately seven meters away from
the transmitter when you press the "Auto Scan" button.
