Hot-swap mobile rack
An additional external hard drive can be connected behind the front cover via a hot-
swap SATA mobile rack for 2.5” or 3.5” hard drives.
Please bear in mind that only the mobile rack supplied can
be used.
Installing a 3.5” hard drive in a 2.5”/3.5” mobile rack
The mobile rack is made of metal and enables the hard drive to be installed without
the need for tools.
The 2.5”/3.5” mobile rack has a premounted hard drive decoupler, which consists of a
rubber bushing with two thin metal holding pins.
Proceed as follows:
Unlock the mobile rack
7
by pressing the release lever.
Pull the mobile rack out of the slot.
Place the mobile rack onto a fi rm surface with the open side facing upwards. If
necessary, use a soft surface to minimise any knocks or collisions. The handle must
be facing in your direction.
Pull the hard drive decoupler out of the mobile rack.
The upper surface of the hard drive should be facing upwards
with the contacts located in the bottom right.
Now insert the hard drive at an angle into one side of the
mobile rack.
Ensure that both small hooks on the mobile rack slide into the
screw holes on the hard drive. Then carefully allow the hard
drive to slide completely into the mobile rack.
Press the hard drive decoupler back into the mobile rack.
Ensure that both metal pins slide into the screw holes on the
hard drive.
Hard drive
29
34045 EN ALDI AUS Content MSN 2006 4786 final.indb 29
34045 EN ALDI AUS Content MSN 2006 4786 final.indb 29
15.12.2017 07:27:52
15.12.2017 07:27:52
