30 of 78
Telephone:
1300 884 987
Internet: www.medion.com.au
After Sales Support
Now press the WPS button on the router with which you
would like to connect the repeater. This step must be
carried out within two minutes.
The connection is established and network
information is exchanged.
Once the connection has been established, the WPS
LED lights up for 5 minutes.
If the WPS LED flashes, there has been an error
during connection. Wait two minutes until the LED
goes out and restart the connection process.
After the connection has been completely set
up, the signal LED will indicate the quality of the
connection.
To make further settings after the successful
establishment of a WPS connection or to set up the
WPS connection manually after a failed connection
attempt, use the web interface (see page 44).
After the repeater has been successfully configured
via the WPS button, you can use the LAN cable to
connect the repeater to the LAN port on the device
that is to be connected via wireless to the network.
Bear in mind the range of the access point (home
router). The Wireless LED lights up when reception is
good and flashes for poor reception.
86977 EN ALDI AUS Content Final 50045465_REV2.indd 30
86977 EN ALDI AUS Content Final 50045465_REV2.indd 30
12.07.2013 10:14:13
12.07.2013 10:14:13
