14
End of operation
End of operation
1. Switch off the appliance.
2. Unplug the cord.
3. Press the release knob
3
to allow the arm to raise itself.
4. Remove the mixing tool. To release the tool, rotate it counterclockwise.
5. Rotate the mixing bowl
5
slightly clockwise to remove it.
6. When the dough is ready, use a spatula to remove it from the mixing bowl.
7. Clean the parts used as described under “Cleaning”.
Cleaning
WARNING!
Risk of injury!
There is a risk of injury from electric shock.
− Before cleaning, turn the control knob to speed setting
0
and remove the plug.
− Before cleaning, remove all attachments.
− Never immerse the appliance in water or other liquids!
− Always unplug the appliance from the outlet before removing attachments and cleaning.
NOTICE!
Risk of damage to the appliance if handled incorrectly
− Do not use a wire brush, scouring pad or scouring cleaning agents.
− The splash guard is not heat-resistant. Do not set the dishwasher temperature higher than
50 °C.
Motor housing:
− Only clean the external housing of the appliance, using a damp cloth with a small amount of
soap. Dry off with a cloth.
Whisk, dough hook, beater and mixing bowl:
− These parts can be cleaned with hot water and soap or in the dishwasher. Do not use any
scouring agents.
Plastic accessories, beater and mixing bowl:
− These parts can be cleaned with hot water and soap or in the dishwasher. Do not use any
scouring agents.
Troubleshooting
Problem
Possible cause
Solution
The appliance will
not start
The mains plug is not
properly inserted.
Pull out the plug, wait 10 seconds and then plug it back in
again.
The socket is defective.
Check the socket by connecting another appliance.
