6
Onni - Standing frame instructions
Timoteos Oy
4.
Supine or prone setup
4.1 Head rest
On the backside of the thoracic
trunk support pad are two holes
for attaching the head rest.
Adjust the trunk pad a bit upward
in order to reach the screws
properly without obstacles.
4.2 Tray
In supine setup the tray shafts
should point outward from
underneath the tray.
For prone setup, the shafts are
fully under the tray.
Open the screw holding the shaft
and flip the shaft around (4.2.1).
Make sure that the head of the
screw on the inside of the ”ear”
of the tray goes in one of the
holes on the shaft and the other
hole is aligned with the angle
adjustment groove
For prone setup, the tray has to
be inserted into place before use
(4.2.2). The tray holder may
have to be lifted above the trunk
pad in order to slide the tray over
the pad.
4.3 Foot rests
Foot rests with the heel
blocks are very simple to
turn around by loosening
the screw underneath.
4.1
4.2.1
4.3
4.2.2
Multistand 2000 User Manual