22
The triangular pad guiding gets plugged from the back side
The stamping in the pad guiding must be positioned into the long
hole.
At least 2 washer get plugged and the wing nut gets firmly tightened.
After loosening the wing nut it is possible to adjust the trunk pad
steplessly concerning the height. By twisting from the horizontal to
the upright position it is possible to adjust the width of the pads to
each other.
After reaching the desired position and tightening the wing nuts the
back upholstery is pushed underneath the trunk pads.
The angle of the trunk pad is fixed by tightening the clamping screw
underneath the trunk pad cover.
Whenever you change any settings on the
BINGO
Evolution
, make sure that you firmly tighten any
screws that have been loosened.
5.9 Lap belt
On each end of the lap belt you can find pre mounted triglides, which
are passed by the belt only once.
The length of the free belt ends determine the length of the complete
lap belt.
• Pass the free belt ends as shown through the long holes in the
backrest.
• Then thread the belt ends once again through the triglides.
Open the lap belt by pushing the red key on the buckle.
The lap belt can be adjusted by pulling the belt end next to the
buckle (Precision tuning).
80
81
82
83
84
