Battery installation or replacement
When the battery symbol appears on the display, this means that the batteries must be replaced.
Proceed following the instructions below.
Make certain that the appliance is turned off.
Remove the cover and insert 4x1,5V AA alkaline batteries, according to the polarity symbols.
Replace the cover correctly.
If the appliance will not be used for an extended period of time, it is recommended that you
remove the batteries.
MAINTENANCE.
This appliance does not require special maintenance. Clean it regularly.
Use a soft, damp cloth to clean the appliance and the cuff.
Air dry the cuff and do not iron it.
Do not use abrasive products or chemical solvents.
DO NOT IMMERSE THE APPLIANCE IN WATER.
No component can be maintained by user in the monitor. The circuit diagrams, component
part lists, descriptions, calibration instructions, or other information which will assist the user’s
appropriately qualified technical personnel to repair those parts of equipment which are
designated repairabely can be supplied.
It is recommended the performance should be checked every 2 years or after repair. Please
contact the service center.
Avoid high temperature and solarization
It is recommended the cuff should be disinfected 2 times every week if needed (For example,
in hospital or in clinique). Wipe the inner side (the side contacts skin) of the cuff by a soft cloth
squeezed after moistened with Ethyl alcohol (75-90%), then dry the cuff by airing. 2. Clean the
cuff after the usage of every 200 times is recommended.
The monitor can maintain the safety and performance characteristics for a minimum of 10,000
measurements or three years
The cuff integrity is maintained after 1,000 open–close cycles of the closure.
Summary of Contents for m246
Page 57: ......