Step 1. Material inspection
It is very important to carry out a visual inspection of the packaging of the baby changing station in order to
ensure that it has not suffered any damage during transport and handling. If damage to the packaging is
found, the changing station should be carefully inspected to see if it has suffered any damage.
UNDER NO
CIRCUMSTANCE SHOULD THE BABY CHANGING STATION BE INSTALLED IF ANY DAMAGE IS
FOUND.
Remove all packaging material and check if any assembly component (bed with wall installation structure
and sanitary liner dispenser) or any hardware component (see table of fixings supplied) is missing.
Step 2. Preparation of the installation surface
Once the material is unpacked and inspected, choose the area on the wall where the baby changing
station will be installed. It is very important to keep in mind and respect the operating distances indicated in
the figure below, which are
9” (228 mm) on either side of the chassis for fixing the changing station to the
wall and
22 1/2” (570 mm) of the changing station bed, when it is open, from the wall.
The recommended installation height is
31 1/2” (800 mm) from the ground to the lowest part of the
changing station. The following sketch shows the height at which the holes should be made in order for the
changing station to be installed at the recommended height:
Summary of Contents for Saniflow CP0016H-ASTM
Page 32: ......
Page 33: ...www saniflowcorp com 33 ...
Page 34: ......
Page 35: ...www saniflowcorp com 35 ...
