www.saniflowcorp.com
-3-
Required tools
You will need the following tools for the installation of the baby changing station:
Measuring tape in order to install the changing station
to the appropriate height and distance
Phillips Head Screwdriver in order to tighten the
fasteners of the changing station
A level in order for the changing station to be installed
completely horizontal to the ground
A pencil for the appropriate installation markings
A drill to make all the necessary holes for the
installation
13/32” (Ø 10mm) masonry drill bit (a special drill for
brick, masonry or cement walls with widia tip).
Fixings supplied
The following fixings are supplied with the baby changing station:
Six self-tapping Philips screws (DIN 7981/C A2 of
Ø6.3x70 mm) for fixing the changing station to the wall
Six
Ø
10mm nylon plugs to insert into the installation holes
of the changing station
Four flat washers (DIN125 M8 A2) to be mounted with
four Ø6.3x70 mm self-tapping Philips screws below the
metal structure
Four blunt Philips screws (DIN7985 A2 M4x8 mm) to
fasten the liner dispenser to the metal wall structure
Four flat washers (DIN125 M4 A2) to be mounted with
four blunt Philips screws (M4x8 mm) to fasten the liner
dispenser
INSTALLATION INSTRUCTIONS
Summary of Contents for Saniflow CP0016H-ASTM
Page 32: ......
Page 33: ...www saniflowcorp com 33 ...
Page 34: ......
Page 35: ...www saniflowcorp com 35 ...
