4134.A
4
Set-up Instructions
1.
Remove the TEMP 1
from the box; check the unit before operating to ensure that all of the
packaging materials or manuals are removed from the cabinet.
2.
Locate the Documentor
and remove from the shipping box. Attach the Documentor
to the
TEMP 1
following the instructions below.
Place the TEMP 1
on its front. Remove and keep the two screws from the top and left
side. See the picture.
Align the holes in the TEMP 1
Time/Clock Mounting Bracket to the empty screw
holes. Secure the mounting bracket using the screws removed in step one.
Remove the 3 screws in the back of the Documentor
. Attach the Documentor
to the
mounting bracket using these 3 screws.
3.
Plug the Documentor
into the Hospital Grade Receptacle located on the side of the TEMP 1
.
4.
Use the Mounting Diagram to place four mounting bolts either on a wall or a cart. The TEMP
1
loaded with 6 bags of solution will weigh approximately 29 pounds. When mounting to a
wall, care should be taken to secure the mount to the wall using bolts suitable for the wall
material to support a minimum of 90 lbs. Leave the heads of the mounting bolts 1/16” out from
the wall, position the TEMP 1® mounting brackets over the heads of the bolts and slide into
place.
5.
An optional kit (MSI-K725) is available for mounting the TEMP 1
on an I.V. pole.
6.
Locate the electrical cord and plug the TEMP 1
into an approved outlet.
Remove this
screw
Top of the TEMP 1
Remove this screw
Do not remove these
screws.
