Medias Mediatrix 1204, Reference Manual

Page: 44 / 390

Chapter 1 - Installation LED Indicators
18 Mediatrix 1204
AdminMode LED Pattern Description
While in the AdminMode state, the LEDs of the Mediatrix 1204 behave independently; the following table
indicates the behaviour for each LED.
Recovery Mode LED Patterns
There are two different sequences of LED patterns indicating that a recovery is in process.
At Start-Time
When pressing the Default Settings switch at start-time, the state sequence goes as follows:
Figure 7: LED Pattern at Start-Time
At Run-Time
When pressing the Default Settings switch at run-time, the state sequence goes as follows:
Figure 8: LED Patterns at Run-Time
Table 13: LED Patterns in AdminMode
LED Pattern Meaning
Ready Blinking 1 Hz 75% Ready and Power LEDs blink off phase at 180 degrees
In Use Steady Off All analog lines are not available.
LAN
(HW Ctrl)
Steady On Ethernet connection detected.
Steady Off Ethernet connection not detected.
Blinking (variable rate) Ethernet activity detected.
Power Blinking 1 Hz 75% Ready and Power LEDs blink off phase at 180 degrees
Button Held Button Released
Booting RecoveryModePending RecoveryMode
Button Held After (5 sec)
Button Released
OpModes
ResetPending
RecoveryModePending
Booting RecoveryMode