Medias Mediatrix 1204, Reference Manual

Page: 218 / 390

Chapter 14 - Gateway Configuration Detecting a Far End Disconnect
192 Mediatrix 1204
2. Set the timeout after which to release the FXO line in the fxoFeocOnSilenceDetectionTimeout
variable.
Available values range between 1 and 300 seconds. The default value is 300 .
3. Restart the Mediatrix 1204 so that the changes may take effect.
Forced End of Call on Far End Tone Detection
The Mediatrix 1204 can monitor special tones that indicate the remote SCN user has hung up. You can use
the default value for a selected country or customize a tone.
Table 118 lists the default frequency and cadence
detected by supported country.
When customizing a tone, Mediatrix suggests to ask your Central Office about the tone it generates to indicate
a call has been disconnected. You will thus be able to customize your tone according to this information.
Table 118: Default Frequency and Cadence Supported
Country Frequency
Cadence
ON1 (s) OFF1 (s)
Australia 425 Hz 8.0 0.0
Austria 450 Hz 8.0 0.0
Brazil 425 Hz 8.0 0.0
China 450 Hz 8.0 0.0
France 440 Hz 8.0 0.0
Germany 425 Hz 8.0 0.0
Hong Kong 440 Hz 8.0 0.0
Indonesia 425 Hz 8.0 0.0
Israel 400 Hz 8.0 0.0
Italy 425 Hz 0.2 0.2
Japan 400 Hz 8.0 0.0
Malaysia 425 Hz 8.0 0.0
Netherlands 425 Hz 8.0 0.0
New Zealand 400 Hz 0.5 0.5
North America 440 Hz 8.0 0.0
Russia 425 Hz 8.0 0.0
Spain 425 Hz 8.0 0.0
Sweden 425 Hz 8.0 0.0
Switzerland 425 Hz 8.0 0.0
Thailand 400 Hz 8.0 0.0
UK 440 Hz 8.0 0.0