Medialink MLC 62 IR D, User Manual, Page: 14 / 70

Features,
Installation, and
Operation
This section describes the front, side, and rear panel features of the five MLC models, and
provides procedures for installing and operating them. Topics include:
•
Installation Overview
• Front and Left Side Panels
• Installation
• Configuring the MLC via the USB Port
•
Mounting the MLC 60 Series Controllers
• Accessing Covered Panel Features After Mounting
• Front Panel Security Lockout
• Resetting the MLC Using the Reset Button
•
IR Learning
Installation Overview
1. Prepare the installation site as follows:
a. Measure and cut the hole in the mounting surface (see Mounting the MLC 60
Series Controllers , beginning on page 34).
b. Prepare and pull the cables through the electrical box or mounting bracket.
c. Install the electrical box or mounting bracket. (Installation instructions for the
electrical box are provided with it.)
2. (Optional) Make desired changes to the buttons installed in the faceplate, substituting
any of the provided additional buttons (see
Replacing Buttons on page 23).
NOTE: The
Mute
button on the MLC 64 volume control module cannot be
changed.
3. Attach the cables to the rear panel connectors of the MLC and to the display device
or switcher. Attach optional IR Emitters if used, and any switches or sensors needed
for other room devices, such as lights, a motorized screen, and so forth). See the
following sections as needed for cabling information:
•
Rear Panel Features
•
Wiring for RS-232 Control (RS Models Only)
•
Wiring for IR Control
•
Wiring the Relays Port (RS Models Only)
•
Wiring the Digital Input Port (RS Models Only)
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation 8