Mounting the MLC 60 Series Controllers
When the system has been cabled, configured, and tested, the MLC can be installed
in a wall or furniture. After you have any desired changes to the faceplate or front panel
buttons and configured the buttons, mount the MLC as described in the following
sections.
Mounting the MLC 62 D
You can mount an MLC 62 RS D or MLC 62 IR D to a UL-approved one-gang sized
electrical junction box or Decora mounting bracket (included).
Mounting an MLC 62 D to an electrical junction box
ATTENTION:
•
Ensure that the junction box is grounded properly.
•
Assurez vous que le boîtier d’encastrement est correctement mis à la terre.
1.
Mount the electrical junction box in the wall or furniture, following the directions
provided with the box.
2.
Run the cables through the electrical box.
3.
Connect all cables and disconnect power from all devices at the source.
4.
Insert the MLC unit into the mounted electrical box.
5.
Secure the MLC to the box using two of the provided screws in the slots at the top
and bottom of the unit.
6.
Fasten the Decora wallplate onto the unit using two of the provided screws in the
holes at the top and bottom.
Electrical
Box
Decora
Wallplate
VOLUME
DISPL
AY
OF
F
ON
MUTE
LAPTOP
VIDEO
PC
MLC 62 D
Figure 35.
Mounting an MLC 62 D in an Electrical Junction Box
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation
34