MANTAINANCE
Warning: Before performing any mantainance, please disconnect the appliance from the
network.
Clean this dryer using a soft cloth dampened with water and detergent.
To ensure the durability and reliability of this product, periodically check that the grid
inlet and outlet of the cone are not clogged by dust or any equivalent material
FILTER EPA E11 filter paper
The Epa filter inside the machine, if present, guarantees air to be cleaned from excessive
dust and dirt. The filter must be periodically cleaned with a jet of compressed air at a
distance of about 20 cm. It must be replaced after a maximum of 1000 hours of use, in
conjunction with the cartridges motor brushes. The quality E11 HEPA filter paper, if
maintained in good condition and replaced as required above,it is able to protect against
bacteria and external factors that can go up to 97.66% of airborne particles.
BRUSH MOTOR (carbon brushes)
The motor brushes cartridge in the drive unit has a life of 1000 hours of effective operation.
The duration of the same varies depending on the conditions of use and of cleaning the filter
and general mantainance of the appliance. It is needed to contact the service in order to
restore the brushes at the end of the cycle.
General warnings
Do not use this product for a different function from that to which it is intended :HAND
DRYER
• Do not leave the appliance exposed to atmospheric conditions such as rain, sun, etc..
• Make no changes of any kind to the device
• Do not obstruct the air outlet or mouth
• Do not insert any object into the grid or the outlet air
In case of failure and / or malfunction, remove the mains and consult with the manufacturer
or dealer
IMPORTANT INFORMATION
This product falls within the competence of the EC Directive 2002/96 (WEEE) on disposal
of electrical and electronic equipment. Complies with RoHS legislation
NOTE:
This product should not be disposed with household waste.
Recycle it at the appropriate structures.
Ask your local authority for recycling guidelines.
TROUBLE SHOOTING GUIDE
Continous operating
on electric board decrease sensor sensibility by turning unclockwise the
white trimmer on board
N
ot operating
check all connections first ,then change the electric board if necessary
