Hardware Installation Guide - Mediatrix Sentinel
18
• Connect a PSTN or a PBX to the FXO card.
Caution:
To prevent damage to the Mediatrix unit, make sure to connect the cables to their
proper location on the Mediatrix unit.
10)
Connect the Ethernet Cables. Refer to:
•
Using the Mediatrix Unit in the LAN without a DHCP (p. 19)
•
Using the Mediatrix unit in the LAN with a DHCP (p. 19)
•
Using the Mediatrix Unit on the Edge (p. 18)
Installing the Unit on a Flat Surface
Before you start
Warning
:
Before performing this procedure, you must first read and understand the Safety
Recommendations listed in this document.
Steps
1)
Unpack the unit and go through the
2)
Apply the Bumpon
™
autoadhesive protective products to the bottom of the unit.
This will improve the airflow under the unit.
3)
Install the unit on the flat surface.
4)
Make sure the unit is at 20 cm (8 inches) from your monitor, computer casing, or other peripheral,
including speakers.
Next Step
(p. 17)
Using the Mediatrix Unit on the Edge
Before you start
• Your computer must be set to use the 192.168.0.11 private IP address.
• Make sure that your network connection is working.
• Refer to the Hardware Installation Guide for instructions on how to properly install and connect
the telephony card.
Steps
1)
Make sure an adequate earth ground connection has been made between the grounding screw on
the back of the Mediatrix unit and an appropriate grounding point in your site.
Warning
:
Adequate earth grounding connection of the Mediatrix unit is mandatory to avoid
any damage or injuries.
2)
Connect a 10/100/1000 BaseT Ethernet RJ-45 cable into the ETH5/EXT Ethernet connector of the
Mediatrix Sentinel.
3)
Connect the other end of the cable into your PC.
