Cards
Copyright © 2015
25
You can insert any type of card in any of the slots, but you must use the slots from 1 to 8,
without leaving slots empty between two cards. Slot order is indicated on the front of the
Sentinel (left bottom corner). The only restriction is that slot 1 must be a DSP or PRI card.
Be aware that if a card is installed and configured to be used in a slot, moving it to another
slot will cause the configuration of the slot to be lost.
Therefore the card will no longer work until it is reconfigured for the new slot.
8)
Gently remove the blank plate or the existing card.
9)
Gently slide into the internal plastic rails of the slot the new card.
Attention:
Care should be taken to avoid any damage to the electronic parts on the card.
The card, when properly inserted, slides in easily.
10)
Set the thumb screws back into place. Do not over-tighten.
Next Step
(p. 17)
