Service manual P9-0200-S
32 of 82
Version 2.0.2/2012
Medema Production A/S
Checking the rear bar
To get into the bolt, remove the rear fender. This is done by
removing the fi nger screws and wires at the rear and tilts the
seat forward. (See section: Dismantling Hoist / Tilt). Once this is
done, loosen the 2 screws. You can now lift up the controller.
It is recommended to also dismount the batteries.
Verify that the rear bar can move up/down. There must be no
cross play in the bar. If there are cross play in rear bar, then
retighten the bolt. Possibly new bushings.
The contra bolt, who is positioned
behind the cloak.
Pin, which is located under the rear bar.
Summary of Contents for MC Concept 1103
Page 82: ...medemagroup...